| |
Highway FD-50 Foundation Drill
"FD-50" Foundation Pressure Drill
ENGINE:
- John Deere 4045T, Balanced diesel engine 125 HP
- Rated Torque: 328 ft/lbs / 445 Nm
- Fuel: Diesel
- Cooling: Water
TRANSMISSION:
- Make: Funk
- Model: 2000 Series
- Speeds: 3 Forward / 3 Reverse
TORQUE RATING:
- 1st Gear: 61,166 ft/lbs / 82.94 kNm
- 2nd Gear: 26,376 ft/lbs / 35.77 kNm
- 3rd Gear: 10,562 ft/lbs / 14.32 kNm
KELLY BAR:
- Outer Bar: 6” / 152.4 mm
- Solid Inner Bar: 4.25” / 107.95 mm
OUTER KELLY BAR:
- Crowd Force: 23,550 lbs / 104.6 Kn
- Control: Hydraulic reeving cylinder
INNER KELLY BAR WINCH:
- Make: Pullmaster
- Model: M-18
- Capacity: 18,000 lbs / 80.0 Kn
- Line Speed: 195 ft/min / 59 m/min (full drum)
SERVICE WINCH:
- Make: Pullmaster
- Model: PL-5
- Capacity: 5,000 lbs / 22.2 Kn
- Line Speed: 76 ft/min / 23 m/min (full drum)
AUGER CAPACITY:
- 72" Intermittent
- 54" Continuous
HOLE DEPTHS: (STANDARD)
DRIVE GEARS:
- Spiral bevel gears delivering power to kelly bar through a 4
roller drive assembly
ROTATION: (STANDARD)
- Bearing: Rotation ring gear, 53” diameter, gear
reduction box with internal brake system
OUTRIGGERS:
- Rear Supports: Fixed, straight down jacks
- Front Supports: Hydraulic out and down jacks
- Rear Outrigger Spread: 90” / 2.3 m
- Front Outrigger Spread: 134” / 3.4 m
DIMENSIONS:
- Overall Unit Height: 9’ 6” / 2.92 m
- Overall Unit Width: 102” / 2.59 m
- Overall Unit Length: 32’ 4” / 9.85 m
MAST:
- Articulation Over Vertical: 10 degrees
- Side Articulation: 10 degrees left and right
|
|
