Bucket Trucks

Cranes

Digger Derricks

Dump Bodies

Lift Gates

Platform Lifts

Sign Cranes

Tracked Vehicles

Trailers

Truck Bodies

Used Equipment

Rental / Leasing

Repair / Testing

Training

Paint Shop

Parts

Online Store

Contact Us
Financing
About Us
Directions/Travel
Employment
Industry News
Useful Links
 

Versalift T-3100-I/N Insulated and Non-Insulated Telescopic Aerial Bucket Trucks
	Printer friendly version

PLATFORM
The standard fiberglass platform is 24 in. x 24 in. x 42 in. (0.61 m x 0.61 m x 1.07 m) with an inside and outside step for easy access. The standard platform capacity is 350 lbs. (160 kg).

OUTER/INNER BOOM ASSEMBLY
The outer/inner boom assembly includes an outer boom, telescopic inner-boom and extension system. The outer boom consists of an 8 in. x 10 in. (203 mm x 254 mm) rectangular steel section. The telescoping inner boom is housed within the outer boom. The inner boom can be easily removed and disassembled for service and inspection. The extension system consists of a hydraulic cylinder, two integral holding valves, and dual #50 roller chains housed entirely within the boom assembly. The hoses are non-conductive and fully contained within the boom assembly. The outer/inner boom assembly articulates from 25° below horizontal to 85° above horizontal. Actuated by a double acting cylinder that has two, integral holding valves, the outer/inner boom assembly is offset to one side to provide easy access to the platform. A boom support cradle and a boom tie down strap are included.

HYDRAULIC PLATFORM LEVELING
Platform leveling is controlled by a master and slave cylinder. The leveling system can be operated from the upper controls to adjust platform leveling, tilt the platform for clean out, or to ease the removal of an injured operator.

CONTINUOUS ROTATION
Unrestricted rotation is accomplished by a hydraulically driven worm and spur gear with a shear-ball rotation bearing. The critical bolts holding the lift to the rotation bearing and the rotation bearing to the pedestal are SAE grade 8 capscrews. These critical bolts are torque seal marked to provide a quick means of detecting any turning of the bolt.

CYLINDERS
The cylinders are a threaded head cap design. The extension cylinder is equipped with two integral holding valves that prevent down creep and to lock the booms in position in the event of hose failure. The elevation cylinder is equipped with one integral holding valve.

INDIVIDUAL CONTROLS
Individual full-pressure controls at the platform and turret actuate all boom functions. An emergency stop and a tool selector control are located at the upper controls. The lower control station is equipped with a selector valve that can override the upper controls and 180° platform rotation.

ELECTRICAL INSULATION SPECIFICATIONS
The outer/inner boom assembly is tested and certified for electrical work at 46 KV and below in accordance with ANSI A92.2 requirements. The outer/inner boom assembly is fully insulated even in a retracted position.

GENERAL SPECIFICATIONS (Based on 40 in (1.02m) Frame Height)

*NOTE:

1. Specifications may vary without prior notification
2. Required GVWR can vary significantly with chassis, lift mountings location, service body, accessories, and desired payload.

OPTIONS:

• Outriggers
  
• Outrigger/Boom Interlock System
  
• Platform Size Variations
  
• Increased Platform Capacity
  
• Torsion Bar
  
• Two-Speed Manual Throttle Control
  
• Emergency Power

Easy platform access

Platform tilt for easy cleaning